|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 15th, 2005, 05:21 PM
|
|||
|
|||
ignore missing values while ploting graph
what commands do i need to give in order to ignore the missing values when i
am plotting the curve. By ignoring the missing values I will not get any breaks in the plot 
|
|
#2
September 15th, 2005, 06:25 PM
|
|||
|
|||
|
Excel plot Wrote: what commands do i need to give in order to ignore the missing values when i am plotting the curve. By ignoring the missing values I will not get any breaks in the plot Hi Excel plot Use #N/A, this will be ignored -- Paul Sheppard ------------------------------------------------------------------------ Paul Sheppard's Profile: http://www.excelforum.com/member.php...o&userid=24783 View this thread: http://www.excelforum.com/showthread...hreadid=467925
|
|
#3
September 15th, 2005, 06:48 PM
|
|||
|
|||
|
Using the ctrl key, only highlight the cells with values and Insert - Chart.
"Excel plot" wrote: what commands do i need to give in order to ignore the missing values when i am plotting the curve. By ignoring the missing values I will not get any breaks in the plot
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to specify values for X axis in a Graph | Pankaj | Charts and Charting | 1 | September 27th, 2005 05:06 PM |
| unable to repair inobox | Sudheer Mumbai | General Discussion | 1 | February 20th, 2005 11:55 AM |
| Why are the values missing??? | MickJJ | General Discussion | 0 | November 18th, 2004 11:38 AM |
| Interpolating or estimating missing data values in a series for a | John | Setting Up & Running Reports | 0 | November 4th, 2004 01:55 PM |
| Graph - comparing values of 2 series while adding an attribute for each compared values | Chen G | General Discussion | 1 | November 1st, 2004 02:44 AM |
Linear Mode
