If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How can I change the spacing & font in a merge address to match th
I'm using Word for a merge and I cannot change the spacing and font in the
address field to match the body of the letter. I've tried changing the font type, and when I click on the address field, it shows the font to which I've changed it, however, when it prints out, it is a different font type. Thank you. |
#2
|
|||
|
|||
How can I change the spacing & font in a merge address to match th
To start with, don't use the Address Block mergefield, but insert the
individual mergefields in the in the mail merge main document in the configuration that you want them. If that still does not do the trick, press Alt+F9 to toggle on the display of the field codes and inside the closing } insert \* charformat replacing \* mergeformat if it is there. Then select the M of MERGEFIELD and apply the desired formatting to it. Alt+F9 again to toggle off the display of the field codes. -- Hope this helps. Please reply to the newsgroup unless you wish to avail yourself of my services on a paid consulting basis. Doug Robbins - Word MVP "Pauli" wrote in message ... I'm using Word for a merge and I cannot change the spacing and font in the address field to match the body of the letter. I've tried changing the font type, and when I click on the address field, it shows the font to which I've changed it, however, when it prints out, it is a different font type. Thank you. |
Thread Tools | |
Display Modes | |
|
|