If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Page Size on print
I am using Access 2003 and need to change my paper size to be 11X17 but there
is no option for that size in the page setup drop down list. Does anyone know how to set this up so I set the form page size to be 11 X 17 Thanks Andy |
#2
|
|||
|
|||
Page Size on print
You will need a printer driver that supports that size.
Do you have a printer (or at least a printer driver) that supports 11x17? If so, change to that printer and then the 11x17 size will be available. John Spencer Access MVP 2002-2005, 2007-2008 The Hilltop Institute University of Maryland Baltimore County AJOLSON wrote: I am using Access 2003 and need to change my paper size to be 11X17 but there is no option for that size in the page setup drop down list. Does anyone know how to set this up so I set the form page size to be 11 X 17 Thanks Andy |
#3
|
|||
|
|||
Page Size on print
Ahhhh ok now I got it. Thanks !! "John Spencer" wrote: You will need a printer driver that supports that size. Do you have a printer (or at least a printer driver) that supports 11x17? If so, change to that printer and then the 11x17 size will be available. John Spencer Access MVP 2002-2005, 2007-2008 The Hilltop Institute University of Maryland Baltimore County AJOLSON wrote: I am using Access 2003 and need to change my paper size to be 11X17 but there is no option for that size in the page setup drop down list. Does anyone know how to set this up so I set the form page size to be 11 X 17 Thanks Andy |
#4
|
|||
|
|||
Page Size on print
I have the same problem. I am trying to print a report to an 17x11 wide
carriage printer, okidata microline 321. The printer driver is installed for the printer, but I cannot get access to recognize that the report is being printed to a page wider than 8.5x11. "John Spencer" wrote: You will need a printer driver that supports that size. Do you have a printer (or at least a printer driver) that supports 11x17? If so, change to that printer and then the 11x17 size will be available. John Spencer Access MVP 2002-2005, 2007-2008 The Hilltop Institute University of Maryland Baltimore County AJOLSON wrote: I am using Access 2003 and need to change my paper size to be 11X17 but there is no option for that size in the page setup drop down list. Does anyone know how to set this up so I set the form page size to be 11 X 17 Thanks Andy |
Thread Tools | |
Display Modes | |
|
|