If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
RTF2 control
Hi there -
I installed the RTF2 Active X control from www.lebans.com. I got everything working on the form and the reports. However, I have a macro set up to copy the open record. When I do this, the new record that is created results in a bunch of "jibber" in that field. Has anyone seen this before? Thanks! |
#2
|
|||
|
|||
RTF2 control
Is that "gibberish" perhaps the RTF markup language?
-- Doug Steele, Microsoft Access MVP http://I.Am/DougSteele (no e-mails, please!) "jenni_p" wrote in message ... Hi there - I installed the RTF2 Active X control from www.lebans.com. I got everything working on the form and the reports. However, I have a macro set up to copy the open record. When I do this, the new record that is created results in a bunch of "jibber" in that field. Has anyone seen this before? Thanks! |
#3
|
|||
|
|||
RTF2 control
The raw field data contains RTF codes that would look like gibberish if
you did not know what you are looking at. Are you trying to copy the current record bound to a Memo field containing RTF data? WHere are you trying to copy it to? Please post your code. -- HTH Stephen Lebans http://www.lebans.com Access Code, Tips and Tricks Please respond only to the newsgroups so everyone can benefit. "jenni_p" wrote in message ... Hi there - I installed the RTF2 Active X control from www.lebans.com. I got everything working on the form and the reports. However, I have a macro set up to copy the open record. When I do this, the new record that is created results in a bunch of "jibber" in that field. Has anyone seen this before? Thanks! |
Thread Tools | |
Display Modes | |
|
|