|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 4th, 2009, 11:24 AM
posted to microsoft.public.visio.general
|
|||
|
|||
Can't pate correctly
Hello,
can't paste copied Visio file to new Visio blank window correctly - connection lines are broken. Have organization chart in non standard page - modified A2. I think blank page doesn't understant my previous page format. Any ways to fix it and paste correctly, to see 1:1? 
|
|
#2
July 6th, 2009, 12:43 AM
posted to microsoft.public.visio.general
|
|||
|
|||
|
Can't pate correctly
Don't know about the broken lines...
Before you paste to the new page, go to File Page Setup and set all the formating properties to make the blank page match the original source page(e.g., sheet size, orientation). Now the drawing should paste 1:1. I did not experience any broken lines, but my test case was pretty simple. HTH Wapperdude "Laimonas" wrote: Hello, can't paste copied Visio file to new Visio blank window correctly - connection lines are broken. Have organization chart in non standard page - modified A2. I think blank page doesn't understant my previous page format. Any ways to fix it and paste correctly, to see 1:1?
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
