If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
print -fit to custom page
I have a house design that needs to be tiled onto 6 pages. I have set the
printer to use 6 tiled pages. I have locked and then dragged the design ot fit the page, but when I ask for the pruint preview, the design does not fill the sapce. any help wouold be approcetiated. |
#2
|
|||
|
|||
print -fit to custom page
Use a poster setup in page setup.
-- Mary Sauer http://msauer.mvps.org/ "margaret" wrote in message ... I have a house design that needs to be tiled onto 6 pages. I have set the printer to use 6 tiled pages. I have locked and then dragged the design ot fit the page, but when I ask for the pruint preview, the design does not fill the sapce. any help wouold be approcetiated. |
#3
|
|||
|
|||
print -fit to custom page
Aloha Mary,
Thanks for taking the time to reply to my question. The problem is that the object, even though I have locked it and dragged it to cover the entire page, when it shows the preview, does not cover all the pages- it is like it is still fairly small. larger than regular, but not large enough tot fill the pages. does that make sense? margaret "Mary Sauer" wrote: Use a poster setup in page setup. -- Mary Sauer http://msauer.mvps.org/ "margaret" wrote in message ... I have a house design that needs to be tiled onto 6 pages. I have set the printer to use 6 tiled pages. I have locked and then dragged the design ot fit the page, but when I ask for the pruint preview, the design does not fill the sapce. any help wouold be approcetiated. |
Thread Tools | |
Display Modes | |
|
|