|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 7th, 2009, 02:19 AM
posted to microsoft.public.visio.general
|
|||
|
|||
How can I put a long text into a shape?
I have a long dictionary entry I copied from Wikipedia. I like to place it
into my Visio 2003 in such way that only the title would apper inside the shape. The reader would refer to the appendix to read it, or clicking on the shape the full article would come out. 
|
|
#2
July 7th, 2009, 11:55 AM
posted to microsoft.public.visio.general
|
|||
|
|||
|
How can I put a long text into a shape?
"The reader would refer to the appendix to read it", sounds like the entry
is saved in another document (word perhaps). Why not hyperlink to it? al "Flowless flow chart" Flowless flow wrote in message ... I have a long dictionary entry I copied from Wikipedia. I like to place it into my Visio 2003 in such way that only the title would apper inside the shape. The reader would refer to the appendix to read it, or clicking on the shape the full article would come out.
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
