If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Layout
I need some help if anyone has any ideas. I have a preprinted form that I am
trying to generate a report to put the data into when printing. The form is laid out like this. 1 include margin at top and bottom. Leaving 9 inches in the middle. The data is broken into 3 sections on the form. Each being 2 inches tall for the boxes on the form. Then between the boxes is 1 1/2 inches of blank space. I can get the first 2 to fill in correctly but have not figured out how to get the 3rd to show up. So basically i have this 1" top margin 2" data box 1 1/2" blank space 2" data box 1 1/2" blank space 2" data box 1" bottom margin. Any ideas on how to get a report in access to handle this since using a 1" top margin and a report of 3 1/2 inches will not work since it goes over 11 inches? Any help is appreciated |
#2
|
|||
|
|||
Layout
I was able to do this by setting the detail section height to 3 1/2 inches
and then to 2 inches based on the record count in the detail format. I also had to add a page break and set it to visible after the 3rd record each time through. "Dale" wrote: I need some help if anyone has any ideas. I have a preprinted form that I am trying to generate a report to put the data into when printing. The form is laid out like this. 1 include margin at top and bottom. Leaving 9 inches in the middle. The data is broken into 3 sections on the form. Each being 2 inches tall for the boxes on the form. Then between the boxes is 1 1/2 inches of blank space. I can get the first 2 to fill in correctly but have not figured out how to get the 3rd to show up. So basically i have this 1" top margin 2" data box 1 1/2" blank space 2" data box 1 1/2" blank space 2" data box 1" bottom margin. Any ideas on how to get a report in access to handle this since using a 1" top margin and a report of 3 1/2 inches will not work since it goes over 11 inches? Any help is appreciated |
Thread Tools | |
Display Modes | |
|
|