If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Outline Numbering
I produce procedures using outlined numbered lists using three levels of promotion i.e. 1.0, 1.1, 1.1.1. The procedure carrys through the preamble about the procedure for a couple of pages which is OK. It then, on a new page, returns to item 4.0, where the numbering is expanded to the three levels. My problem is - although told to revert back to 4.0, the numbered list on the previous pages also renumber, or, the list refuses to start at 4.0 and carries on numbering as it feels best. Should I be using section breaks?
|
#2
|
|||
|
|||
Outline Numbering
Make sure you have set up your outline numbering according to the
instructions at http://www.shaunakelly.com/word/numb...Numbering.html, and it should be relatively trouble-free. -- Suzanne S. Barnhill Microsoft MVP (Word) Words into Type Fairhope, Alabama USA Word MVP FAQ site: http://word.mvps.org Email cannot be acknowledged; please post all follow-ups to the newsgroup so all may benefit. "Ann" wrote in message ... I produce procedures using outlined numbered lists using three levels of promotion i.e. 1.0, 1.1, 1.1.1. The procedure carrys through the preamble about the procedure for a couple of pages which is OK. It then, on a new page, returns to item 4.0, where the numbering is expanded to the three levels. My problem is - although told to revert back to 4.0, the numbered list on the previous pages also renumber, or, the list refuses to start at 4.0 and carries on numbering as it feels best. Should I be using section breaks? |
Thread Tools | |
Display Modes | |
|
|