If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
set default axis values
have set default after formatting chart through chart / chart types/set as
default setting Then when highlight data and press F11, format revert back to origional setting any ideas to amend? I am trying to set this so as to not keep formating each chart when the operator selects the required data thanks brian -- bnt Message posted via OfficeKB.com http://www.officekb.com/Uwe/Forums.a...chart/200603/1 |
#3
|
|||
|
|||
set default axis values
thanks it works !
Kelly O'Day wrote: You are close, however, you have to take a few additional steps: Step 1 - you need to establish a user defined custom chart type before you can set it as your default chart: Select your formatted chart - right click - select Chart Type, go to Custom Types, then User Defined. Step 2 - Add your chart in the Custom chart - User defined - Add window - give it a name Step 3 - Now you can set your chart as the default F11 should now generate your custom -- user defined chart have set default after formatting chart through chart / chart types/set as default setting [quoted text clipped - 10 lines] brian -- bnt Message posted via http://www.officekb.com |
#4
|
|||
|
|||
set default axis values
Appreciate the reply. It's good to know that response was received and that
it worked. "brian thompson3001 via OfficeKB.com" u15682@uwe wrote in message news:5d33662a0e583@uwe... thanks it works ! Kelly O'Day wrote: You are close, however, you have to take a few additional steps: Step 1 - you need to establish a user defined custom chart type before you can set it as your default chart: Select your formatted chart - right click - select Chart Type, go to Custom Types, then User Defined. Step 2 - Add your chart in the Custom chart - User defined - Add window - give it a name Step 3 - Now you can set your chart as the default F11 should now generate your custom -- user defined chart have set default after formatting chart through chart / chart types/set as default setting [quoted text clipped - 10 lines] brian -- bnt Message posted via http://www.officekb.com |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Default values from one table, entered values in another | laser02910 | Using Forms | 2 | June 21st, 2005 10:01 PM |
Chart X axis values are wrong! | Sorin | Setting Up & Running Reports | 0 | December 17th, 2004 10:05 PM |
catergory on the X axis; values on the Y axis | 100green | Charts and Charting | 1 | December 15th, 2004 07:06 PM |
Non-Numeric values in X axis of a scatter chart | penasm | General Discussion | 1 | October 28th, 2004 05:44 PM |
Default placement for data values in Charts | Ellen | Powerpoint | 2 | July 14th, 2004 03:56 PM |