|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 9th, 2008, 12:27 AM
posted to microsoft.public.visio.general
|
|||
|
|||
Formatting
When I highlight a sentence or word or specific section in a paragraph to
format only that, the whole document changes to the requested format, then when I hit the back arrow, it goes back to the original formatting with the highlighted part now in the new formatting. I know I must have something on or off, but I can't figure it out, I don't think it always did this, I think it just started. I know also I don't need this two steps to be able to format just a single part of a doc. 
|
|
#2
July 9th, 2008, 08:26 AM
posted to microsoft.public.visio.general
|
|||
|
|||
|
Formatting
Are you having trouble with a Text box in Visio ?
"deblmd" wrote: When I highlight a sentence or word or specific section in a paragraph to format only that, the whole document changes to the requested format, then when I hit the back arrow, it goes back to the original formatting with the highlighted part now in the new formatting. I know I must have something on or off, but I can't figure it out, I don't think it always did this, I think it just started. I know also I don't need this two steps to be able to format just a single part of a doc.
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
