If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
easy control data value question
I have a report which has on it a text box
when I enter the data value for the control as ProjectName it works fine when I enter the data value for the control as CurrentIssueTitle it works fine (both are in the report's data source) however, when I enter: = [ProjectName] & chr(13) & chr(10) & [CurrentIssueTitle] the result is an #error# even if I simply enter: = [ProjectName] & [CurrentIssueTitle] the result is an #error# it's still an error any suggestions would be greatly appreciated in advance, Mark ....learning something new every day |
Thread Tools | |
Display Modes | |
|
|