If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Printing & Footer
Hi Guys
I am hoping someone can help. I have a watermark on the edge of my page at the far right hand bottom corner of the page on both right and bottom edge of the page but when i print the page there is a gap which i dont want i want the page to print with the logo on the edgingwithout the gap how can i do this? Regards Saeed |
#2
|
|||
|
|||
Printing & Footer
That's a matter of your printer's capability. Most non-commercial printers
require a minimum margin on one or more sides & are not capable of a full bleed [printing to the absolute edge of the paper]. Even most of those which can print borderless photos can only do so on stock smaller than letter size... Sometimes there are specific settings which have to be adjusted through the driver software in order to do that. You can try setting you margins to ZERO, but even that will not help. Check your printer's documentation or check in with the mfr's support site. -- HTH |:) Bob Jones Office:Mac MVP "Saeed" wrote in message ... Hi Guys I am hoping someone can help. I have a watermark on the edge of my page at the far right hand bottom corner of the page on both right and bottom edge of the page but when i print the page there is a gap which i dont want i want the page to print with the logo on the edgingwithout the gap how can i do this? Regards Saeed |
Thread Tools | |
Display Modes | |
|
|