|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 9th, 2004, 06:41 PM
|
|||
|
|||
Visio for Enterprise Archiects - how to reverse engineer a Yukon d
where do i obtain the driver for this?
currently error is this db ver. is not supported...get a driver.... 
|
|
#2
October 9th, 2004, 08:12 PM
|
|||
|
|||
|
would you like to share with us the vendor and version of db you are trying
to find???? "Bryan Farrell" Bryan wrote in message ... where do i obtain the driver for this? currently error is this db ver. is not supported...get a driver....
|
|
#3
October 9th, 2004, 10:51 PM
|
|||
|
|||
|
sql server 2005(Yukon).
"Al Edlund" wrote: would you like to share with us the vendor and version of db you are trying to find???? "Bryan Farrell" Bryan wrote in message ... where do i obtain the driver for this? currently error is this db ver. is not supported...get a driver....
|
|
#4
October 11th, 2004, 09:31 PM
|
|||
|
|||
|
Well, I'd suspect that if neither the current sql driver, nor the generic
odbc drivers work you might have to wait for Yukon to deliver them. I apologize for missing your note about "Yuk". Al "Bryan Farrell" wrote in message ... sql server 2005(Yukon). "Al Edlund" wrote: would you like to share with us the vendor and version of db you are trying to find???? "Bryan Farrell" Bryan wrote in message ... where do i obtain the driver for this? currently error is this db ver. is not supported...get a driver....
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| can i forward engineer Visio ER diagram to SQL Server physical sc. | ankur | Visio | 1 | September 22nd, 2004 06:36 PM |
| Compare Visio Technical 5 and Visio Professional | Evelyn | Visio | 2 | May 27th, 2004 07:25 PM |
Linear Mode
