|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 24th, 2004, 03:36 PM
|
|||
|
|||
Printing: Text in a shape
I have put two names in the topmost shape of my org chart. When I print the document, after pdf'ing it, only two of the six lines print. Any solutions?
|
|
#2
May 25th, 2004, 12:30 PM
|
|||
|
|||
|
Printing: Text in a shape
If the document prints correctly to a postscript printer, then the pdf
should be correct. This is typically a print driver set of issues. Al "Yssentle" wrote in message ... I have put two names in the topmost shape of my org chart. When I print the document, after pdf'ing it, only two of the six lines print. Any solutions?
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
