If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
autostart macro
is it posible to run a excellmacro directly after i load
an excell file |
#2
|
|||
|
|||
autostart macro
John, use the workbook open event put in the this workbook module like this
Private Sub Workbook_Open() 'your code here End Sub -- Paul B Always backup your data before trying something new Using Excel 2000 & 97 Please post any response to the newsgroups so others can benefit from it ** remove news from my email address to reply by email ** "john" wrote in message ... is it posible to run a excellmacro directly after i load an excell file |
#3
|
|||
|
|||
autostart macro
I am looking for a response to the same question. I handled the problem by covering up the data with a picture with instructions to start the program by clicking on the picture. I have done all kinds of things to make this picture unmovable by the client so the data could not be seen. I will send you a copy this whole program if you want it. The file with the macro is less than 1k and you can see what I have done with this. I have not found, and I have looked, for a way to auto start a macro at file load.
respond by email. I dont know where this info is posted Stan H |
Thread Tools | |
Display Modes | |
|
|