If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Huge header: how can I reduce it?
A one-page Word doc (2003*) I've been given to work with has a big table in
the main part, with what appear to be small regions of header and footer. However, if you actually "View Header", the dotted line showing the header boundary shows that it extends way down to below the bottom row of the table. Yet there are no paragraph marks or anything to show why this might be. I had a chance to edit an earlier version of this document, and found that I couldn't insert text before or after the table without running foul of header/footer issues. I guess this is why. Anyway, there are two actual text lines in the header. I need to remove the second and put it in the main body so that it's easily accessible in a mail merge. Any hints about how I could proceed? (*probably edited in 2007) David |
#2
|
|||
|
|||
Huge header: how can I reduce it?
Often this just means that the vertical alignment for the section has been
set to Center rather than Top. -- Suzanne S. Barnhill Microsoft MVP (Word) Words into Type Fairhope, Alabama USA http://word.mvps.org "David Powell" wrote in message ... A one-page Word doc (2003*) I've been given to work with has a big table in the main part, with what appear to be small regions of header and footer. However, if you actually "View Header", the dotted line showing the header boundary shows that it extends way down to below the bottom row of the table. Yet there are no paragraph marks or anything to show why this might be. I had a chance to edit an earlier version of this document, and found that I couldn't insert text before or after the table without running foul of header/footer issues. I guess this is why. Anyway, there are two actual text lines in the header. I need to remove the second and put it in the main body so that it's easily accessible in a merge. Any hints about how I could proceed? (*probably edited in 2007) David |
Thread Tools | |
Display Modes | |
|
|