If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Access 2003
Hi,
I have Office 2003 installed and when ever i open an access file it gives me a security warning, saying it might not be safe. Is there anyway i can get rid of it. Remebering the file was orignally created in Office XP. But its just annnoying the msg coming up. Anyone else with the same problem, preferably with a solution for it. thankyou |
#2
|
|||
|
|||
Access 2003
Click Tools, Macro, Security. Then, switch the security
level to Low. Derek Jones Software Support Specialist Shenandoah University Winchester, VA -----Original Message----- Hi, I have Office 2003 installed and when ever i open an access file it gives me a security warning, saying it might not be safe. Is there anyway i can get rid of it. Remebering the file was orignally created in Office XP. But its just annnoying the msg coming up. Anyone else with the same problem, preferably with a solution for it. thankyou . |
#3
|
|||
|
|||
Access 2003
kewl awsome, thanx Derek
|
#4
|
|||
|
|||
Access 2003
Actually, it doesn't work.
there is no security tab under Tools-Macro. and i don't know how to change it in Tools-Security. |
#5
|
|||
|
|||
Access 2003
If the security tab isn't available,
1) Verify you've install Jet 4 SP8 (http://windowsupdate.microsoft.com) 2) Right click the menubar/toolbar in a blank spot and choose Customize..., go to the Toolbars tab and select Menu Bar, click the Reset... button. -- Wayne Morgan MS Access MVP "Hasan" wrote in message ... Actually, it doesn't work. there is no security tab under Tools-Macro. and i don't know how to change it in Tools-Security. |
#6
|
|||
|
|||
Access 2003
Go into View, toolbars, customize and reset the Main Menu.
-- Joan Wild Microsoft Access MVP "Hasan" wrote in message ... Actually, it doesn't work. there is no security tab under Tools-Macro. and i don't know how to change it in Tools-Security. |
Thread Tools | |
Display Modes | |
|
|