If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Status Bar Text
If I open a new form prior to closing the calling form the status bar text does not appear, it just says 'Ready'. It doesn't matter where I go on the form I cannot get the text to change. Is there any way (other than using syscmd for every control) that I can reset this behaviour.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Too many hyperlinks? | [email protected] | Powerpoint | 7 | May 25th, 2004 02:19 AM |
Edit same text in multiple locations | angelo11 | Formatting Long Documents | 2 | May 19th, 2004 06:24 PM |
Edit same text in multiple locations | Angelo | Formatting Long Documents | 3 | May 19th, 2004 03:43 PM |
Vertical Text Orientation | Paul Anderson [MSFT] | Visio | 0 | May 11th, 2004 05:16 PM |
Text boxes-help | Jon Peltier | Charts and Charting | 0 | January 26th, 2004 05:46 PM |