If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Charting dynamic range
Ok let me say i fully understand how to name a range and in the source data
use the formula =sheetname!rangename Problem arrises when my macro that runs an advanced filter with the source data and add data to the bottom of the range the chart reverts back to it's initial data source =sheet1!$a$4:$b$15 so even though it accept the named range intitailly once the advanced filter runs it almost ommits the named range. I am using 2007 and i never had this problem in 2003. What suggestions do you have for me? Thank you!!!!! -- Thank you, Jennifer |
Thread Tools | |
Display Modes | |
|
|