If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
graphic designer needs help!
I have created a form in Quark which originally was required by the client to
be printed out and then filled in by hand. Now, the client wishes the same form to be filled out in Word as and when necessary. I don't use Word very often so don't really know my way around it but so far have come up with the conclusion of bringing the Quark form artwork into Word as a png image and then drawing various tables on top in the relevant spaces. However, I have been unable to get the tables to position exactly where I want them - they seem to snap into positions. Am I doing it the right way? And if so, how can I get more control over the tables I draw? |
#2
|
|||
|
|||
graphic designer needs help!
Use the Table properties dialog to precisely size/position the elements of
your table. -- Hope this helps. Please reply to the newsgroup unless you wish to avail yourself of my services on a paid consulting basis. Doug Robbins - Word MVP "Vic112" wrote in message ... I have created a form in Quark which originally was required by the client to be printed out and then filled in by hand. Now, the client wishes the same form to be filled out in Word as and when necessary. I don't use Word very often so don't really know my way around it but so far have come up with the conclusion of bringing the Quark form artwork into Word as a png image and then drawing various tables on top in the relevant spaces. However, I have been unable to get the tables to position exactly where I want them - they seem to snap into positions. Am I doing it the right way? And if so, how can I get more control over the tables I draw? |
Thread Tools | |
Display Modes | |
|
|