Access does not support printing in reduced or enlarged mode.

You can redesign the report using smaller or larger fonts.

As far as changing the orientation - open the report and use the page set up
to change the orientation. A problem is that if you are printing landscape
then you are probably going to end up printing a section of the right side of
the current report on a separate page. The fix for that is to move controls
around to keep the printing on one vertical page wide.

John Spencer
Access MVP 2002-2005, 2007-2010
The Hilltop Institute
University of Maryland Baltimore County

forest8 wrote:
Hi there

Currently, when my report prints, it is in landscape.

How can I change it so that it prints portrait and is reduced 75%?

Is it possible to set this up in a macro?

Thank you