Thread
:
Controlling connectors on cross-overs (intersections)
View Single Post
#
2
May 11th, 2010, 06:40 PM posted to microsoft.public.visio.general
AlEdlund
external usenet poster
Posts: 468
Controlling connectors on cross-overs (intersections)
The ability to control the 'lines' is limited to connectors. To change how
the route go to page setup, select layout and routing and adjust line jumps.
al
"Mike McCarty" Mike
wrote in message
...
When two connector lines intersect, one of them will have a break or won't
have a break depending on the behavior settings for those lines. How does
one make one line jump over the other line with a half circle (standard
pipeline nomenclature for cross-overs)? Also, is it possible to have
regular
lines behave this was too, or only connector type lines?
Thanks, Mike
AlEdlund
View Public Profile
View message headers
Find all posts by AlEdlund
Find all threads started by AlEdlund