On Wed, 19 May 2010 20:26:01 -0700, HWL wrote:
I use Visio to mark up PDFs from an architect, which are each the size of
their specific project. I do not print them locally but must re-generate a
PDF in the same size as the original. That size is not listed in the Printer
Paper pull down (Architectural E2 for example). Therefore I cannot return a
marked up project in the size needed. How do I make a paper size without a
printer attached locally?
http://www.windowsitpro.com/article/...-printer-.aspx
--
Regards, Paul Herber, Sandrila Ltd.
Electronics for Visio
http://www.sandrila.co.uk/visio-electronics/
Electrical for Visio
http://www.sandrila.co.uk/visio-electrical/
Electronics Packages for Visio
http://www.sandrila.co.uk/visio-electronics-packages/