Ok. I figured VB6 just meant it was a newer version of VBA (where I put the
codes/modules). At any rate, I gave up on the idea last night when I found a
work around (not pretty, but it works). Thanks everyone for your help.

"Rick Brandt" wrote:

mb wrote:
Thanks for your help. I don't know if the site I was looking at
(http://msdn.microsoft.com/en-us/libr...32(VS.60).aspx was
specifically for a data access page, but I'm hoping to use this in an
Access database form.

That page pretty clearly describes itself as a VB6 page, not an Access page.
The control it describes cannot be used in Access unless there is an ActiveX
version of it that you could utilize (bad idea).

--
Rick Brandt, Microsoft Access MVP
Email (as appropriate) to...
RBrandt at Hunter dot com