On Fri, 29 Aug 2008 09:11:30 -0700 (PDT), Paul
wrote:
On Aug 26, 9:30*am, Paul Herber
wrote:
On Tue, 26 Aug 2008 06:15:45 -0700 (PDT), Paul
wrote:
Is there a way to control the radius of rounding for the rounded
corners of a rectangle? *I opened up the shape sheet, and it looks
like it might be controlled in the "Geometry 1" table. *Ideally, I'd
like the rounding radius to scale with the minimum of the height and
width, but manually specifying it would be just as good.
select the shape(s)
menu Format - Line
and select from the rounding area, you acn set a rounding radius
manually.
Hi, Paul,
The resulting menu shows a perfectly pointy corner. Even pressing
some of the rounded corners and clicking Apply doesn't round the
corner of the rectangle. Would your method be for lines/interconnects
rather than shapes/rectangles?
No, it seems to work on most shapes, I've just tried it on the PC
shape from the Computers and Monitors stencil. That looks rather
funny!
--
Regards, Paul Herber, Sandrila Ltd.
Electronics for Visio
http://www.electronics.sandrila.co.uk/