On Mon, 26 Apr 2010 18:19:02 -0700, vfont wrote:

I was using Visio 2010 Premium this morning to modify a multi-page UML
Activity Diagram and something went teriibly wrong. The diagram was created
in Vision 2007. There are four pages in the diagram. Pages 2-4 are minor
variations of the same process. When I created the diagram and cut and pasted
each diagram from page 2 to it's own new page, then tweaked each diagram for
uniqueness. When I was done, I grouped everything together

That's probably the step where it all went wrong. There is no need to group these shapes,
in fact, it will be positively detrimental. Ungroup them and all should be well. (Only
ungroup the shapes that you grouped, don't ungroup the shapes that Visio creates as
groups)


--
Regards, Paul Herber, Sandrila Ltd.
Electronics for Visio http://www.sandrila.co.uk/visio-electronics/
Electrical for Visio http://www.sandrila.co.uk/visio-electrical/
Electronics Packages for Visio http://www.sandrila.co.uk/visio-electronics-packages/