Hi Stephen,

Stephen Lebans schrieb:
It's a known bug. It happens when a report is formatted improperly
so that a single report page will not fit on one output page. Usually
it's simply the margin settings are too large for the current
printer. I'll bet you are either working with a a non US page size or
your current printer is an Ink Jet and the bottom margin is greater
than the .5 inch setting on the sample reports.
Open any of the sample Reports in design view, modify the paper size
or Margins to allow the report to fit onto your current page setup.
Try the conversion process again and it will work properly. I just
found the OLE Structured Storage
information required to fix this issue. I will add logic to remove
this error in the next release.

Because I thought that the problem is the papersize, i have changed the
papersize of my default printer to US page size, but it didn' work.

I can't open the Reports in design view, because your downloads are MDE.

I have tested the output with my own MDB and my own report. The error is the
same :-(.

--
So long Dieter