I did not ungroup the Visio supplied shapes. I only ungrouped the shapes that
I orginally grouped together and copied from page to page. I could edit them
fin in 2007. After installling 2010, the shapes are mysteriously linked
across all the pages. If I change the text in a shape on page 4, the
corresponding shape on page 2 also changes the text. This is a software
issue, not something that I'm doing wrong. I a 25 year veteran of software
development and use visio extensively to illustrate books I write. The only
way to fix the problem is to completely redraw the diagram in 2010. It is an
enormous waste of time and loss of productivity.

"Paul Herber" wrote:

On Mon, 26 Apr 2010 18:19:02 -0700, vfont wrote:

I was using Visio 2010 Premium this morning to modify a multi-page UML
Activity Diagram and something went teriibly wrong. The diagram was created
in Vision 2007. There are four pages in the diagram. Pages 2-4 are minor
variations of the same process. When I created the diagram and cut and pasted
each diagram from page 2 to it's own new page, then tweaked each diagram for
uniqueness. When I was done, I grouped everything together

That's probably the step where it all went wrong. There is no need to group these shapes,
in fact, it will be positively detrimental. Ungroup them and all should be well. (Only
ungroup the shapes that you grouped, don't ungroup the shapes that Visio creates as
groups)


--
Regards, Paul Herber, Sandrila Ltd.
Electronics for Visio http://www.sandrila.co.uk/visio-electronics/
Electrical for Visio http://www.sandrila.co.uk/visio-electrical/
Electronics Packages for Visio http://www.sandrila.co.uk/visio-electronics-packages/
.