View Single Post
  #7  
Old September 15th, 2007, 01:26 AM posted to microsoft.public.word.tables
Sue D
external usenet poster
 
Posts: 5
Default Table Header Row doesn't repeat

That was the problem!! I selected None and my headings appeared. Thank you.

"Doug Robbins - Word MVP" wrote:

On the Table tab of the Table Properties dialog, make sure that Text
wrapping is set to None in the bottom half of the dialog.

--
Hope this helps.

Please reply to the newsgroup unless you wish to avail yourself of my
services on a paid consulting basis.

Doug Robbins - Word MVP

"Sue D" wrote in message
...
I revealed hidden formatting codes and looked through three times for
section
or page breaks and did not see any. Table Properties shows only row 1 as
the
header row. I'm not sure what you mean by not wrapped. If you mean the
table is wider than the paper, I changed Table Properties to set the table
width at 100% and still have the problem.

"Doug Robbins - Word MVP" wrote:

The following has previously been posted when that problem has come up:

Make sure the table is not wrapped and has no breaks and that you don't
have
all the rows set as heading rows.


--
Hope this helps.

Please reply to the newsgroup unless you wish to avail yourself of my
services on a paid consulting basis.

Doug Robbins - Word MVP

"Sue D" wrote in message
...
I have a table with row 1 defined as a repeating header row. Table
Properties confirms the setting. However, the row does not repeat on
any
page. I cannot find a manual page break in the table. I have run a
repair
of the software. This table is 16 pages long so a header row is
desired.